Chevrolet brake issues resolved

Brake
Brake is a "safety factor" in a car, but it is safe to say that the average driver rarely gives thoughts until it is so worn that it is ineffective.

Brake linings
These are made from woven asbestos and copper wire.

If the brakes are not properly adjusted and the lining is not evenly distributed on the drum, life will be relatively short, no matter how well made.

"Howl or squeak" when applying brakes
This is because the lining of the brake lining is worn and the head of the rivet holding the lining to the band hits the drum or the lining surface is polished.If the rivet is protruding, remove the band and sink the rivet head under the lining.If the lining is too thin, replace it.

The one-wheel lock
brake when applying the car skid or brake is not evenly adjusted.That is, one wheel grip is in front of the other wheel grip.Jack up the rear of the car and adjust the pull rod between the brake and the brake shaft so that the left and right brake bands grip the wheel equally at the same pressure at the same time.

Brakes are not held on the hill,
which indicates that the lining is not evenly supported and is gripping only half of the band.This

Article Source